Fender

Removal and Installation

NOTE: Removal steps in this procedure may contain installation details.

1. Remove the front bumper cover. For additional information, refer to Section 501-19 .

2. Remove the fender splash shield. For additional information, refer to Fender Splash Shield in this section.

4. 1. • To install, tighten to 9 Nm (80 lb-in).
   2. -

5. • To install, tighten to 9 Nm (80 lb-in).

6. • To install, tighten to 9 Nm (80 lb-in).

7. • To install, tighten to 9 Nm (80 lb-in).

8. NOTE: If reusing an existing fender baffle, use a locally obtained flexible foam repair expandable foam sealant to seal the area around the entire perimeter of the fender baffle.

   Cutting knife.

9. Remove the cowl panel grille. Refer to Cowl Panel Grille .

10. NOTICE: Make sure clip is fully released prior to lifting up or damage to the component may occur.

11. • To install, tighten to 9 Nm (80 lb-in).

13. To install, reverse the removal procedure.