SECTION 501-08: Exterior Trim and Ornamentation
2014 Flex Workshop Manual
REMOVAL AND INSTALLATION
Procedure revision date: 05/02/2013

Window Moulding — A-Pillar


Material
Item Specification
Seam Sealer
TA-2 		—

Removal

  1. Using a non-marring body tool, pry outward to release the upper A-pillar window moulding clip.
  1. Using a non-marring body tool, pry outward to release the 2nd A-pillar window moulding clip.
  1. Slide the window moulding upward to release the remaining clips.

  1. NOTE: Twist the window moulding clips to remove them from the body.

    Remove the window moulding clips from the body and attach them to the window moulding.

Installation

  1. Apply seam sealer to the rubber gaskets around each of the window moulding clips.
  1. Starting at the bottom, align the A-pillar window moulding clips.
  1. Carefully snap the A-pillar window moulding clips into place.