SECTION 501-10: Seating
2014 Flex Workshop Manual
GENERAL PROCEDURES
Procedure revision date: 05/02/2013

Seat Wire Harness Routing

  1. For correct front passenger seat cushion wire harness routing, refer to the following views.

  1. NOTE: Illustration shows Occupant Classification System (OCS) weight sensor bolts in their installed position with the seat in the vehicle (arrow indicates front).

    Verify the correct passenger seat OCS weight sensor bolt electrical connector positions using the illustration.
 

Power Passenger Seat Track

Wire Harness View

NOTE: Illustrations show wire harness with heat. If not equipped with heat option, skip heated seat numerical option content.



Item Description
1 Seat wire harness main retainer
2 Occupant Classification Sensor (OCS) weight sensor bolt D wire harness retainer
3 OCS weight sensor bolt D electrical connector
4 Front height motor electrical connector
5 Seat wire harness main retainer
6 Safety belt buckle and pretensioner wire harness retainer
7 Safety belt buckle and pretensioner wire harness retainer
8 Safety belt buckle and pretensioner electrical connector and retainer
9 Seat wire harness main electrical connector and retainer
10 Seat control switch wire harness retainer
11 Cushion heater mat electrical connector and retainer
12 Seat control switch wire harness retainer
13 Occupant Classification System Module (OCSM) electrical connector
14 Rear height motor electrical connector
15 Heated seat module electrical connector (large)
16 Heated seat module electrical connector (small)
17 Belt Tension Sensor (BTS) wire harness electrical connector and retainer
18 BTS wire harness retainer
19 OCS weight sensor bolt C wire harness retainer
20 Horizontal motor electrical connector
21 OCS weight sensor bolt C wire harness retainer
22 OCS weight sensor bolt C electrical connector
23 Cushion heater mat component side electrical connector and retainer
24 Side air bag electrical connector and retainer
25 Backrest wire harness retainer
26 Backrest wire harness retainer
27 Backrest wire harness electrical connector and retainer
28 Seat control switch electrical connector a
a Make sure the wire harness passes on the correct side as shown.


Wire Harness Retainer and Connector Location View

NOTE: See supporting views for missing numbers.



Retainer and Connector Location View, Outboard Side From Underneath


Retainer and Connector Location View, Front Inboard


Retainer and Connector Location View, Outboard Side


Retainer and Connector Location View, Backrest


Retainer and Connector Location View, Seat Control Switch


Wire Harness Installed View
  1. Make sure the passenger seat cushion wire harness is correctly routed and attached.
 

Manual Passenger Seat Track

Retainer and Connector Location View, Cushion Frame From Underneath

NOTE: See supporting views for missing numbers.



Item Description
1 Occupant Classification System Module (OCSM) electrical connector
2 Belt Tension Sensor (BTS) wire harness retainers
3 BTS wire harness retainer
4 BTS wire harness electrical connector and retainer
5 Side air bag module electrical connector and wire harness retainer
6 Safety belt buckle and pretensioner wire harness retainer
7 Safety belt buckle and pretensioner wire harness retainer
8 Safety belt buckle and pretensioner electrical connector
9 OCS weight sensor bolt D electrical connector
10 OCS weight sensor bolt C wire harness retainer a
11 OCS weight sensor bolt C electrical connector
12 Seat wire harness main electrical connector and retainer
a Make sure the wire harness passes on the correct side of seat track lever as shown.


Retainer and Connector Location View, Outboard Side of Seat


Retainer and Connector Location View, Front of Seat Track
  1. Make sure the passenger seat cushion wire harness is correctly routed and attached.