SECTION 501-10: Seating
2014 Flex Workshop Manual
REMOVAL AND INSTALLATION
Procedure revision date: 05/02/2013

Seat Armrest

Removal and Installation

NOTE: For parts identification and location, refer to Seat — Exploded View, Second Row in this section.

  1. Remove the center occupant head restraint guide sleeves. For additional information, refer to Head Restraint Guide Sleeve in this section.
  1. Detach the backrest cover retainer at the bottom, at the inboard side and open the backrest cover.
  1. Detach the armrest cover retainers from the hard back panel.
  1. Remove the armrest assembly.
    1. Separate the hook-and-loop strip at the bottom and pull the backrest cover out at the top.
    1. Pull the 3 backrest cover retainers out from between the hardback panel and backrest frame.
    1. Remove the 3 armrest-to-backrest frame bolts.
      • To install, tighten to 20 Nm (177 lb-in).
    1. Detach the 2 retaining clips, pull out at the front and remove the armrest assembly.
  1. To install, reverse the removal procedure.