Seat Cushion Cover — Second Row, 60 Percent

Removal and Installation

NOTE: For parts identification and location, refer to Seat — Exploded View, Second Row in this section.

1. From under the seat, detach the 2 sets of cushion cover J-clips, 1 side retainer and separate the cushion cover from the lower anchor and tethers for children wires.

2. NOTE: Typical cushion cover retainer shown, others similar.

   Detach the cushion cover retainers and pull them out from between the riser and cushion frame.

3. Detach the cushion cover J-clip from the cushion frame.

4. NOTICE: Use care when separating the cushion cover from the hook-and-loop strip or the hook-and-loop strip may be torn from the cushion foam pad.

   Turn the cushion cover inside out, separate the hook-and-loop strips, remove the hog rings and the cushion cover.

5. To install, reverse the removal procedure.
   • Make sure the lower anchor and tether for children wires at the rear of the cushion frame are positioned through the cushion cover and accessible for use after installation.