2014 Flex Workshop Manual

SECTION 501-10: Seating	2014 Flex Workshop Manual
REMOVAL AND INSTALLATION	Procedure revision date: 05/02/2013

Seat Cushion Cover — Second Row, 40 Percent

Removal and Installation

NOTE: For parts identification and location, refer to Seat — Exploded View, Second Row in this section.

Open the cushion cover.
1. Release the clip and separate the strut.
1. Separate the J-clips.
1. Separate the hook-and-loop strips.

NOTE: Typical cushion cover retainer shown, others similar.
From under the seat, detach the 4 cushion cover retainers and pull them out from between the cushion frame and seat track.

Remove the cushion foam pad and cushion cover from the cushion frame.
- If equipped, disconnect the cushion heater mat electrical connector.

Remove the hog rings and the cushion cover.

To install, reverse the removal procedure.
- Make sure the lower anchor and tether for children wires at the rear of the cushion frame are positioned through the cushion trim cover and accessible for use after installation.