Glass, Frames and Mechanisms

The glass, frames and mechanisms consist of the following:

• Accessory delay relay
• FCIM
• Front door glass top run
• Front door window glass
• Front door window regulator and motor
• HVAC module
• Rear door fixed glass and top run
• Rear door glass run retainer
• Rear door window glass
• Rear door window regulator and motor
• Rear quarter glass
• Rear window glass
• Rear window defrost grid
• Rear window defrost relay
• Roof glass panel (if equipped)
• Window control switches
• BCM
• Windshield glass

The glass, frames and mechanisms include the following:

• Standard plastic and laminate windshield glass
• Rear window glass, which houses the rear defrost grid and rear wiper
• Windshield glass, which is bonded to the opening flange with a urethane adhesive
• Standard power windows, which include one-touch up/down (left front only) and rear window lock-out feature.

The window regulator control switch:

• is located on each door trim panel.
• may be used to raise or lower all windows from the left front window control switch, or the individual side window from the corresponding individual door switch.
• can lock out rear window control switches when the lock-out switch on the left front window control switch is turned on.
• can automatically lower the driver door window when the window control switch is momentarily pressed into the second detent position and released.
• can automatically raise the driver door window when the window control switch is momentarily pulled to the second detent position and released.

Delayed accessory feature

The accessory delay relay, located in the BCM , provides voltage for the operation of the power windows and the roof opening panel (if equipped). The delayed accessory feature is active when the ignition is in the RUN or the ACC position, or when the ignition is changed from RUN or ACC to the OFF/LOCK position and the LH and RH front doors are closed.

Rear window defrost

The defrost relay, located in the BJB , is controlled by the HVAC module. The HVAC module activates the rear window defrost relay when the rear window defrost switch (integral to the FCIM ) is pressed. If equipped, the rear window defrost can also be activated/deactivated by using a touchscreen interface or voice commands. When the rear window defrost relay is active, the rear window defrost grid is energized.

If equipped, the customer can select different climate control modes/preferences when the vehicle is started using the remote start feature. When the rear defrost is set to AUTO mode, the rear window defrost activates when the outside temperature is less than 0° C (32° F). Once the ignition is cycled to the ON position, the climate control system returns to the previous settings (last ignition ON cycle) and adjustments can be made normally. For additional information on how to set the remote start preferences, refer to the Owner's Literature.