SECTION 501-14A: Handles, Locks, Latches and Entry Systems — Without Intelligent Access (IA)
2014 Flex Workshop Manual
REMOVAL AND INSTALLATION
Procedure revision date: 05/02/2013

Driver Door Module (DDM)


Item Part Number Description
1 — Driver Door Module (DDM) electrical connectors (part of 14631)
2 W705314-S424 DDM screws (2 required)
3 13C791 DDM

Removal and Installation

  1. NOTE: This step is necessary only if the Driver Door Module (DDM) is being replaced.

    NOTE: Prior to the replacement of the module, it is necessary to upload the module configuration information to the scan tool. This information must be downloaded into the new module after installation. For additional information, refer to Section 418-01 .

    Upload the module configuration information from the DDM . For additional information, refer to Section 418-01 .
  1. Remove the LH door trim panel. For additional information, refer to Section 501-05 .
  1. Position the water shield aside and disconnect the DDM electrical connectors.
  1. Remove the 2 screws and the DDM .
  1. To install, reverse the removal procedure.