Keyless Entry Keypad Code Programming

Remote Function Actuator (RFA) Module Keyless Entry Keypad Code Reset

NOTE: This step is for transferring the factory keyless entry keycode from the BCM and programming it into the RFA module.

1. Using a scan tool, follow the on-screen instructions to perform the keyless entry keypad code reset.
   • The keyless entry keypad code reset procedure is found on the scan tool under Toolbox>Body>Security.

Programming a Personal Entry Code

NOTE: The system allows 4 personal codes to be programmed using the keyless entry keypad.

NOTE: Multiple personal codes can be programmed in a single step. When programming multiple codes in a single step, each code must be programmed by entering each button within 5 seconds of each other. If 5 seconds elapse between any button press, programming mode is exited.

NOTE: If only a single personal code is desired or unable to program multiple codes in one step, each personal code can be programmed individually by repeating Steps 1-5 for each code desired.

1. Enter the factory set 5-digit keyless entry keypad code.

2. Within 5 seconds, press the 1/2 button on the keypad to activate the programming mode.

3. Enter the new 5-digit keyless entry keypad code. Each number must be entered within 5 seconds of each other.

4. NOTE: For vehicles equipped with memory seats, the factory-set code cannot be associated with a memory setting.

   To associate the entry code with a new memory setting, enter a sixth digit to indicate which driver should be set in a memory recalled by the personal entry code:
   • Pressing 1/2 stores the first personal code (and recalls Driver 1 settings if equipped with memory seats).
   • Pressing 3/4 stores the second personal code (and recalls Driver 2 settings if equipped with memory seats).
   • Pressing 5/6 stores the third personal code (does not recall a memory setting if equipped with memory seats).
   • Pressing other keypad buttons stores the fourth personal code (does not recall a memory setting if equipped with memory seats).

5. The doors lock and unlock to confirm the new code is programmed.

Erasing a Personal Entry Code

1. Carry out the procedure to program a personal keyless entry code, but enter the factory set 5-digit keyless entry keypad code into all 4 personal code slots.

2. All personal codes are now erased and only the factory set 5-digit code works.