Wiper Mounting Arm and Pivot Shaft

Removal and Installation

1. Remove the cowl panel grille. For additional information, refer to Section 501-02 .

2. Remove the 3 wiper mounting arm and wiper pivot shaft bolts.
   • To install, tighten to 18 Nm (159 lb-in).

3. Disconnect the electrical connector and detach the wire harness pin-type retainer.

4. Remove the wiper mounting arm and wiper pivot shaft.

5. To install, reverse the removal procedure.
   • Adjust the wiper pivot arms. For additional information, refer to Wiper Blade and Pivot Arm Adjustment — Windshield in this section.