Washer Pump and Reservoir

Removal and Installation

NOTE: Removal steps in this procedure may contain installation details.

2.  WARNING: Carefully read cautionary information on product label. For emergency medical information seek medical advice. In the USA or Canada on Ford/Motorcraft products call: 1-800-959-3673. For additional information, consult the product Material Safety Data Sheet (MSDS) if available. Failure to follow these instructions may result in serious personal injury.

   Extract the fluid with a syringe.

4. With the vehicle in NEUTRAL, position it on a hoist. Refer to Section 100-02 .

5. Remove the RH front fender splash shield. Refer to Section 501-02 .

8. • To install, tighten to 9 Nm (80 lb-in).

9. NOTE: Front bumper cover removed for clarity.

   • To install, tighten to 9 Nm (80 lb-in).

11. NOTICE: Do not operate the washer pump prior to filling the washer reservoir. Failure to follow this instruction may result in premature washer pump failure.

    To install, reverse the removal procedure.
    • Fill the washer reservoir with washer fluid.