SECTION 501-17: Roof Opening Panel
2014 Flex Workshop Manual
GENERAL PROCEDURES
Procedure revision date: 05/02/2013

Roof Opening Panel Manual Operation

  1. Remove the LH and RH A-pillar trim panels.
  1. Remove the LH and RH sun visor assemblies.
  1. Remove the sun visor clip retainer screws and remove the sun visor clips.
  1. Remove the overhead console. For additional information, refer to Section 501-12 .
  1. If equipped, disconnect the auto-dimming electrical connector from the interior rear view mirror.
  1. Pull down front of headliner to gain access to the roof opening panel motor.
  1. Insert an Allen wrench into the center of the manual drive hole. Rotate the Allen wrench counterclockwise until the roof opening panel is closed.