SECTION 501-20A: Safety Belt System
2014 Flex Workshop Manual
REMOVAL AND INSTALLATION
Procedure revision date: 05/02/2013

Safety Belt Retractor — Second Row, Outboard, Without Inflatable Safety Belts

NOTE: RH shown, LH similar.


Item Part Number Description
1 — Safety belt D-ring bolt (part of 611B68)
2 611B68 Second row safety belt retractor
3 — Second row safety belt retractor bolt (part of 611B68)
4 — Second row safety belt anchor bolt (part of 611B68)

Removal and Installation

 WARNING: All safety belt components must be inspected and corrected as part of any collision repair. Inspect all safety belt components as prescribed by Safety Belt Inspection and Repair After a Collision found in Section 501-20A General Procedures of this manual. Failure to follow this instruction may result in incorrect operation of the safety belt system and increase the risk of serious personal injury or death in a crash.

  1. Remove the safety belt retractor anchor bolt.
  1. Remove the C-pillar and quarter trim panels. For additional information, refer to the Removal and Installation portion of Section 501-05 .
  1. Remove the D-ring bolt.
  1. Remove the bolt and safety belt retractor.

  1. NOTE: Before installation, make sure the safety belt webbing is not twisted and the safety belts and buckles are accessible to the occupants.

    To install, reverse the removal procedure.
  1. Check the active restraint system for correct operation. For additional information, refer to the appropriate Functional Test procedure in Safety Belt System in this section.