Safety Belt Shoulder Height Adjuster

NOTE: RH shown, LH similar.

Removal and Installation

 WARNING: All safety belt components must be inspected and corrected as part of any collision repair. Inspect all safety belt components as prescribed by Safety Belt Inspection and Repair After a Collision found in Section 501-20A General Procedures of this manual. Failure to follow this instruction may result in incorrect operation of the safety belt system and increase the risk of serious personal injury or death in a crash.

1. Remove the upper B-pillar trim panel. For additional information, refer to Section 501-05 .

2. Remove safety belt shoulder height adjuster.
   • Remove the bolt.
   • Rotate the safety belt shoulder height adjuster and remove it from the B-pillar.
   • To install, tighten to 40 Nm (30 lb-ft).

3. NOTE: Before installation, make sure the safety belt webbing is not twisted and the safety belts and buckles are accessible to the occupants.

   To install, reverse the removal procedure.

4. Check the active restraint system for correct operation. For additional information, refer to the appropriate Functional Test procedure in Safety Belt System in this section.