SECTION 501-20A: Safety Belt System
| 2014 Flex Workshop Manual
|
REMOVAL AND INSTALLATION
| Procedure revision date: 05/02/2013
|
Safety Belt Buckle — Second Row, Without Inflatable Safety Belts
NOTE:
40 percent shown, 60 percent similar.
| Item
| Part Number
| Description
| | 1
| —
| Safety belt buckle bolt (part of 60044)
|
| 2
| 60044
| Safety belt buckle
|
| 3
| —
| Inboard pivot cover
|
| 4
| —
| Lock washer (part of 60044)
|
Removal and Installation
WARNING: All safety belt components must be inspected and corrected as part of any collision repair. Inspect all safety belt components as prescribed by Safety Belt Inspection and Repair After a Collision found in Section 501-20A General Procedures of this manual. Failure to follow this instruction may result in incorrect operation of the safety belt system and increase the risk of serious personal injury or death in a crash.
- Fold the seat backrest down and tip the seat cushion up.
- Remove the inboard pivot cover.
- Remove the bolt and safety belt buckle.
- To install, tighten to 40 Nm (30 lb-ft).
- To install, reverse the removal procedure.
- Check the active restraint system for correct operation. Refer to the appropriate Functional Test procedure in
Safety Belt System
.