SECTION 501-20A: Safety Belt System
| 2014 Flex Workshop Manual
|
REMOVAL AND INSTALLATION
| Procedure revision date: 05/02/2013
|
Safety Belt Buckle — Third Row
NOTE:
RH shown, LH similar.
| Item
| Part Number
| Description
| | 1
| —
| LH inboard pivot cover
|
| 2
| —
| RH inboard pivot cover
|
| 3
| —
| RH safety belt buckle bolt (part of 613D48)
|
| 4
| 613D48
| RH safety belt buckle
|
Removal and Installation
WARNING: All safety belt components must be inspected and corrected as part of any collision repair. Inspect all safety belt components as prescribed by Safety Belt Inspection and Repair After a Collision found in Section 501-20A General Procedures of this manual. Failure to follow this instruction may result in incorrect operation of the safety belt system and increase the risk of serious personal injury or death in a crash.
- Remove the safety belt buckle.
- Remove the inboard pivot covers.
- Fold the seatback down and position the seat in the vertical position.
- Remove the bolt and safety belt buckle.
- To install, tighten to 40 Nm (30 lb-ft).
- To install, reverse the removal procedure.
- Check the active restraint system for correct operation. For additional information, refer to the appropriate Functional Test procedure in
Safety Belt System
in this section.