SECTION 501-20A: Safety Belt System
2014 Flex Workshop Manual
REMOVAL AND INSTALLATION
Procedure revision date: 05/02/2013

Safety Belt Buckle — Second Row, 40 Percent, With Inflatable Safety Belts


Item Part Number Description
1 63804 RH/63805 LH Cushion cover
2 63840 RH/63841 LH Cushion foam pad
3 56910 Screw (5 required)
4 63386 Seat track inboard inner cover
5 60044 RH/60045 LH Safety belt buckle
6 W715688 Safety belt buckle bolt
7 63388 Seat track inboard outer cover

Removal

 WARNING: All safety belt components must be inspected and corrected as part of any collision repair. Inspect all safety belt components as prescribed by Safety Belt Inspection and Repair After a Collision found in Section 501-20A General Procedures of this manual. Failure to follow this instruction may result in incorrect operation of the safety belt system and increase the risk of serious personal injury or death in a crash.

NOTE: The SRS must be fully operational and free of faults before releasing the vehicle to the customer.

  1. Depower the SRS . Refer to Section 501-20B .
  1. Remove 5 screws and the inboard seat track inner and outer covers.
  1. Detach the cushion cover front and inboard retainers.
  1. Lift the cushion cover and foam pad. Disconnect the safety belt buckle switch electrical connector.
  1. Remove the bolt and the safety belt buckle.

Installation

  1. Position the safety belt buckle on the inflator tube and install the bolt.
  1. Connect the safety belt buckle switch electrical connector.
  1. Reposition the cushion foam pad, cushion cover and engage the front and inboard retainers.
  1. Position the seat track inboard inner and outer covers and install the 5 screws.
  1. Repower the SRS . Refer to Section 501-20B .
  1. Check the active restraint system for correct operation. REFER to Safety Belt System