SECTION 501-20B: Supplemental Restraint System
| 2014 Flex Workshop Manual
|
REMOVAL AND INSTALLATION
| Procedure revision date: 05/02/2013
|
NOTE: LH shown, RH similar.
| Item | Part Number | Description |
|---|---|---|
| 1 | 14B345 | Front impact severity sensor |
| 2 | W505256 | Front impact severity sensor bolt |
| 3 | — | Front impact severity sensor electrical connector (part of 14A411) |
WARNING: If a vehicle has been in a crash, inspect the restraints control module (RCM) and the impact sensor (if equipped) mounting areas for deformation. If damaged, restore the mounting areas to the original production configuration. A new RCM and sensors must be installed whether or not the airbags have deployed. Failure to follow these instructions may result in serious personal injury or death in a crash.
NOTE: Always make sure the correct Supplemental Restraint System (SRS) component is being installed. Parts released for other vehicles may not be compatible even if they appear physically similar. Check the part number listed in the Ford Catalog Advantage™ or equivalent to make sure the correct component is being installed. If an incorrect SRS component is installed, DTCs may set.
NOTE: The air bag warning indicator illuminates when the correct Restraints Control Module (RCM) fuse is removed and the ignition is ON.
NOTE: The SRS must be fully operational and free of faults before releasing the vehicle to the customer.
All vehicles
LH side impact sensor
RH side and vehicles with a 3.5L
GTDI
engine
All vehicles
WARNING: Always tighten the fasteners of the restraints control module (RCM) and impact sensor (if equipped) to the specified torque. Failure to do so may result in incorrect restraint system operation, which increases the risk of personal injury or death in a crash.
NOTE: Make sure the front impact severity sensor and mating surfaces are clean and free of foreign material.
Remove the bolt and front impact severity sensor.