SECTION 501-20B: Supplemental Restraint System
2014 Flex Workshop Manual
REMOVAL AND INSTALLATION
Procedure revision date: 05/02/2013

Occupant Classification System Module (OCSM) — Manual Seat Track


Item Part Number Description
1 — Occupant Classification System Module (OCSM) electrical connector (part of 14D230)
2 14B422 OCSM
3 — OCSM screws

Removal

NOTE: The air bag warning indicator illuminates when the correct Restraints Control Module (RCM) fuse is removed and the ignition is ON.

NOTE: TheSupplemental Restraint System (SRS) must be fully operational and free of faults before releasing the vehicle to the customer.

  1. Depower the SRS . For additional information, refer to Supplemental Restraint System (SRS) Depowering and Repowering in the General Procedures portion of this section.
  1. Disconnect the Occupant Classification System Module (OCSM) electrical connector.
  1. Remove the 2 screws and OCSM .
  1. To install, reverse the removal procedure.
  1. Repower the SRS . Do not prove out the SRS at this time. For additional information, refer to Supplemental Restraint System (SRS) Depowering and Repowering in the General Procedures portion of this section.
  1. Carry out the Occupant Classification Sensor (OCS) System Reset procedure. For additional information, refer to Occupant Classification Sensor (OCS) System Reset in the General Procedures portion of this section.