2014 Flex Workshop Manual

SECTION 501-20B: Supplemental Restraint System	2014 Flex Workshop Manual
REMOVAL AND INSTALLATION	Procedure revision date: 05/02/2013

Passenger Airbag

Item	Part Number	Description
1	04320	Instrument panel upper section
2	19B680	Air duct
3	W701152	Passenger air bag module nut (6 required)
4	044A74	Passenger air bag module
5	W707607	Air duct screws (6 required)

Removal and Installation

WARNING: Always carry a live airbag with the deployment door, trim cover or tear seam pointed away from the body. Do not place a live airbag down with the deployment door, trim cover or tear seam facing down. Failure to follow these instructions may result in serious personal injury in the event of an accidental deployment.

NOTE: The air bag warning indicator illuminates when the correct Restraints Control Module (RCM) fuse is removed and the ignition is ON.

NOTE: The Supplemental Restraint System (SRS) must be fully operational and free of faults before releasing the vehicle to the customer.

Remove the passenger air bag module-to-crossbeam bolts and instrument panel upper section. For additional information, refer to the Instrument Panel Upper Section Removal and Installation procedure in Section 501-12 .
- To install, tighten to 9 Nm (80 lb-in).

Remove the passenger air bag module.
- Remove the 6 screws and air duct.
- Remove the 6 nuts and passenger air bag module.
  - To install, tighten to 6 Nm (53 lb-in).

To install, reverse the removal procedure.