SECTION 303-00: Engine System — General Information
2014 Flex Workshop Manual
GENERAL PROCEDURES
Procedure revision date: 05/02/2013
Valve Seat Width
NOTE:
Refer to the appropriate Section 303-01 for the specification.
Measure the valve seat width. If necessary, grind the valve seat to specification.
Measure the intake valve seat width.
Measure the exhaust valve seat width.
Recheck the valve spring installed length after the seats have been ground, and shim the valve springs as necessary to achieve the correct installed spring length.
Depending on the engine, check the valve lash. Refer to General Procedures in Section 303-01.
