Oil Cooler

Removal

1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to Section 100-02 .

2. If equipped, release the 4 retainers and remove the underbody shield.

3. Using hose clamp pliers, clamp the 2 oil cooler coolant hoses and remove the 2 coolant hoses from the oil cooler.

4. NOTICE: If metal or aluminum material is present in the oil cooler, mechanical concerns exist. Failure to correct these concerns may cause engine failure. To diagnose mechanical concerns, refer to Section 303-00 .

   Remove the 6 bolts and the oil cooler.
   • Discard the gaskets.
   • Clean and inspect all sealing surfaces.

Installation

1. Using a new gaskets, install the oil cooler and the 6 bolts.
   • Tighten in the sequence shown to 10 Nm (89 lb-in).

2. Install the 2 coolant hoses to the oil cooler.
   • Remove the 2 hose clamp pliers.

3. If equipped, install the underbody shield and attach the 4 retainers.