SECTION 303-01A: Engine — 3.5L Ti-VCT
2014 Flex Workshop Manual
IN-VEHICLE REPAIR
Procedure revision date: 05/02/2013
Engine Oil Pressure (EOP) Switch
Material
Item
Specification
Motorcraft® Thread Sealant with PTFE
TA-24
WSK-M2G350-A2
Removal and Installation
With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to
Section 100-02
.
If equipped, release the 4 retainers and remove the underbody shield.
Disconnect the Engine Oil Pressure (EOP) switch electrical connector.
Remove the
EOP
switch.
To install, tighten to 14 Nm (124 lb-in) plus an additional 180 degrees.
To install, reverse the removal procedure.
Apply thread sealant with PTFE to the
EOP
switch threads prior to installation.
