Engine Mount

Removal

1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to Section 100-02 .

2. If equipped, release the 4 retainers and remove the underbody shield.

3. NOTICE: Failure to position the wood block and floor jack as illustrated can result in damage to the oil pan.

   Position a floor jack with a block of wood under the front of the oil pan.

4. Detach the A/C line retainer from the shock tower bracket.

5. Using hose clamp pliers, pinch the lower degas bottle hose and remove the hose from the coolant inlet pipe.

6. Remove the degas bottle. For additional information, refer to Section 303-03 .

7. Remove the 4 engine mount nuts.

8. Remove the 3 bolts and the engine mount.

Installation

1. Install the engine mount and the 3 bolts.
   • Tighten to 90 Nm (66 lb-ft).

2. Install the 4 engine mount nuts.
   • Tighten to 63 Nm (46 lb-ft).

3. Install the degas bottle. For additional information, refer to Section 303-03 .

4. Connect the coolant hose to the coolant inlet pipe.
   • Remove the hose clamp pliers.

5. Attach the A/C line retainer to the shock tower bracket.

6. If equipped, install the underbody shield and attach the 4 retainers.