2014 Flex Workshop Manual

SECTION 303-01B: Engine — 3.5L GTDI	2014 Flex Workshop Manual
IN-VEHICLE REPAIR	Procedure revision date: 05/02/2013

Engine Mount

Item	Part Number	Description
1	8B274	Upper radiator hose
2	W708877	A/C tube bracket bolt
3	W705622	A/C tube retaining clamp bolt
4	W714682	Engine mount-to-engine nut (4 required)
5	W712507	Engine mount-to-frame bolts (3 required)
6	6F012	Engine mount

Removal and Installation

Drain the cooling system. For additional information, refer to Section 303-03 .

Remove the 4 retainers and the underbody shield.

NOTICE: Failure to position the wood block and floor jack as illustrated can result in damage to the oil pan.
Position a floor jack with a block of wood under the front of the oil pan.

Remove the engine coolant degas bottle. For additional information, refer to Section 303-03 .

Disconnect the upper radiator hose from the intake manifold.

Remove the A/C tube bracket bolt from the upper RH shock tower.
- To install, tighten to 15 Nm (133 lb-in).

Remove the A/C tube retaining clamp bolt from the lower RH shock tower.
- To install, tighten to 9 Nm (80 lb-in).

Remove the 4 engine mount nuts.
- To install, tighten to 63 Nm (46 lb-ft).

Remove the 3 bolts and the engine mount.
- To install, tighten to 90 Nm (66 lb-ft).

To install, reverse the removal procedure.

Fill and bleed the cooling system. For additional information, refer to Section 303-03 .