2014 Flex Workshop Manual

SECTION 303-04B: Fuel Charging and Controls — 3.5L GTDI	2014 Flex Workshop Manual
REMOVAL AND INSTALLATION	Procedure revision date: 05/02/2013

Throttle Body — 3.5L GTDI

Item	Part Number	Description
1	W503282	Throttle Body (TB) bolt (4 required)
2	3925	Throttle Position (TP) sensor shield bracket
3	9E936	TB gasket
4	9425	Upper intake manifold
5	14A464	TP sensor electrical connector
6	9E928	TP sensor
7	9N825	Throttle Actuator Control (TAC)
8	—	Charge Air Cooler (CAC) outlet pipe-to- TB clamp (part of 6F073)
9	9E927	TB
10	6F073	CAC outlet pipe
11	14A464	TAC electrical connector

Removal and Installation

Disconnect the Throttle Position (TP) sensor electrical connector.

Disconnect the Throttle Actuator Control (TAC) electrical connector.

Loosen the clamp and disconnect the Charge Air Cooler (CAC) outlet pipe-to-Throttle Body (TB).
- To install, tighten to 5 Nm (44 lb-in).

Remove the 4 bolts, the TB and the TP sensor shield bracket.
- Discard the TB gasket.
- To install, tighten to 10 Nm (89 lb-in).

NOTE: Install a new TB gasket.
To install, reverse the removal procedure.