SECTION 303-14: Electronic Engine Controls
2014 Flex Workshop Manual
REMOVAL AND INSTALLATION
Procedure revision date: 05/02/2013

Powertrain Control Module (PCM) — 3.5L GTDI

Removal

  1. NOTE: PCM installation DOES NOT require new keys or programming of keys.

    Retrieve the module configuration. Carry out the module configuration retrieval steps of the PMI procedure. Refer to Section 418-01 .
  1. Remove the cowl panel grille. Refer to Section 501-02 .

Installation

  1. Install the cowl panel grille. Refer to Section 501-02 .

  1. NOTE: If the PMI procedure was not successful in downloading the data from the vehicle's original PCM, then the oil life data of the vehicle is lost. If this occurs, and the oil life cannot be determined through service history or customer interview, it is recommended the vehicle engine oil and filter be changed and the oil change minder reset.

    Restore the module configuration. Carry out the module configuration restore steps of the PMI procedure. Refer to Section 418-01 .
  1. Reprogram the PATS . Carry out the Parameter Reset procedure. Refer to Section 419-01B .
  1. Using the scan tool, perform the Misfire Monitor Neutral Profile Correction procedure, following the on-screen instructions.