SECTION 204-00: Suspension System — General Information
2014 Flex Workshop Manual
GENERAL PROCEDURES
Procedure revision date: 05/02/2013

Toe Adjustment — Front

  1. Using alignment equipment and the manufacturer's instructions, measure the front toe.
  1. Start the engine and center the steering wheel.
  1. Turn the engine OFF and, using a suitable steering wheel holding device, lock the steering wheel in the straight-ahead position.
  1. Remove the steering gear bellows clamps.
  1. Loosen the nuts.

  1. NOTE: Do not allow the steering gear bellows to twist when the tie rod is rotated.

    Rotate the tie rods as necessary to adjust the toe setting.
  1. Tighten the tie-rod jam nuts to 63 Nm (46 lb-ft).
  1. Recheck the toe settings and adjust as necessary.
  1. Install the steering gear bellows clamps.