SECTION 204-00: Suspension System — General Information
2014 Flex Workshop Manual
GENERAL PROCEDURES
Procedure revision date: 05/02/2013

Toe Adjustment — Rear

  1. Using alignment equipment and the manufacturer's instructions, measure the rear toe.
  1. Start the engine and center the steering wheel.
  1. Turn the engine OFF and, using a suitable steering wheel holding device, lock the steering wheel in the straight-ahead position.
  1. Loosen the tie-rod jam nuts.
  1. Rotate the toe link adjusting rod until the toe setting is within specifications.

  1. NOTE: Do not allow the adjusting rod to rotate while tightening the jam nuts.

    Tighten the tie-rod jam nuts to 40 Nm (30 lb-ft).
  1. Recheck the rear toe and adjust as necessary.