Strut and Spring Assembly

Removal

 WARNING: Do not apply heat or flame to the shock absorber or strut tube. The shock absorber and strut tube are gas pressurized and could explode if heated. Failure to follow this instruction may result in serious personal injury.

 WARNING: Keep all body parts clear of shock absorbers or strut rods. Shock absorbers or struts can extend unassisted. Failure to follow this instruction may result in serious personal injury.

NOTICE: Suspension fasteners are critical parts that affect the performance of vital components and systems. Failure of these fasteners may result in major service expense. Use the same or equivalent parts if replacement is necessary. Do not use a replacement part of lesser quality or substitute design. Tighten fasteners as specified.

1. Remove the wheel and tire. Refer to Section 204-04 .

Installation

1. • Tighten to 63 Nm (46 lb-ft).

2. • Tighten to 225 Nm (166 lb-ft).

3. • Tighten to 150 Nm (111 lb-ft).

4. Install the wheel and tire. Refer to Section 204-04 .

5. Check front camber adjustment. Refer to Section 204-00