SECTION 205-04: Front Drive Halfshafts
2014 Flex Workshop Manual
REMOVAL AND INSTALLATION
Procedure revision date: 05/02/2013

Intermediate Shaft — 3.5L GTDI

Removal

NOTICE: The intermediate shaft seal in the Power Transfer Unit (PTU) must be replaced whenever the intermediate shaft is removed or a leak may occur. For additional information, refer to Section 308-07B .

  1. Remove the right halfshaft assembly. For additional information, refer to Halfshaft — RH in this section.
  1. Discard the specified component. Follow local disposal regulations.

Installation

  1. Install a new 30 mm (1.181 in) circlip on the outboard end of the intermediate shaft.
  1. Install a new intermediate shaft seal in the Power Transfer Unit (PTU). For additional information, refer to Section 308-07B .
  1. Install the right halfshaft. For additional information, refer to Halfshaft — RH in this section.