Brake Caliper Anchor Plate

Removal

 WARNING: Before beginning any service procedure in this section, refer to Safety Warnings in Section 100-00 . Failure to follow this instruction may result in serious personal injury.

NOTE: Removal steps in this procedure may contain installation details.

All vehicles

1. Remove the brake pads. For additional information, refer to Brake Pads — 352 mm (14 in) Brakes or Brake Pads — 325 mm (13 in) Brakes in this section.

Vehicles with 352 mm (14 in) brakes

2. Relocate and support the component.
   • To install, tighten to 75 Nm (55 lb-ft).

All vehicles

3. NOTE: 352 mm (14 in) brakes shown, 325 mm (13 in) brakes similar.

   Discard the specified component. Follow local disposal regulations.
   • To install, tighten to 165 Nm (122 lb-ft).

Installation

1. To install, reverse the removal procedure.