2014 Flex Workshop Manual

SECTION 206-03: Front Disc Brake	2014 Flex Workshop Manual
REMOVAL AND INSTALLATION	Procedure revision date: 05/02/2013

Brake Disc

Material
Item	Specification
Metal Brake Parts Cleaner PM-4-A or PM-4-B (US); CPM-4 (Canada)	—

Removal

WARNING: Before beginning any service procedure in this section, refer to Safety Warnings in Section 100-00 . Failure to follow this instruction may result in serious personal injury.

NOTE: Removal steps in this procedure may contain installation details.

NOTE: 352 mm (14 in) brakes shown, 325 mm (13 in) brakes similar.

Remove the wheel and tire. For additional information, REFER to Section 204-04 .

NOTICE: Do not allow the brake caliper to hang from the brake flexible hose or damage to the hose may occur.
Relocate and support the component. Discard the specified component. Follow local disposal regulations.
- To install, tighten the new bolts to 165 Nm (122 lb-ft).

NOTE: If necessary, thread a M10 bolt into the brake disc removal hole and tighten to press the disc off the hub.
Discard the specified component. Follow local disposal regulations.
- To install, tighten the new screw to 20 Nm (177 lb-in).

Installation

Visual check. Wire brush. Clean the specified component with the specified material.

To install, reverse the removal procedure.