Brake Caliper

Removal

 WARNING: Before beginning any service procedure in this section, refer to Safety Warnings in Section 100-00 . Failure to follow this instruction may result in serious personal injury.

NOTICE: Do not spill brake fluid on painted or plastic surfaces or damage to the surface may occur. If brake fluid is spilled onto a painted or plastic surface, immediately wash the surface with water.

NOTE: Removal steps in this procedure may contain installation details.

NOTE: 352 mm (14 in) brakes shown, 325 mm (13 in) brakes similar.

1. Release the parking brake cable tension. For additional information, REFER to Section 206-05 .

3. Remove the brake flexible hose. For additional information, refer to Brake Flexible Hose in this section.

4. NOTICE: When the brake pads are separated from the brake caliper, new brake pads must be installed to prevent brake noise and shudder. The brake pads are one-time-use only.

   Remove and discard the brake pads. For additional information, refer to Brake Pads in this section.

Installation

1. NOTICE: During installation, make sure that the brake flexible hose does not become twisted or damage to hose may occur.

   NOTE: If equipped, verify correct installation of the brake flexible hose protective sleeve and tie strap.

   To install, reverse the removal procedure.
   • Bleed the caliper. For additional information, refer to Component Bleeding in REFER to Section 206-00 .