SECTION 206-04: Rear Disc Brake
2014 Flex Workshop Manual
REMOVAL AND INSTALLATION
Procedure revision date: 05/02/2013

Brake Disc


Material
Item Specification
Metal Brake Parts Cleaner
PM-4-A or PM-4-B (US); CPM-4 (Canada) 		—

Removal

 WARNING: Before beginning any service procedure in this section, refer to Safety Warnings in Section 100-00 . Failure to follow this instruction may result in serious personal injury.

NOTE: Removal steps in this procedure may contain installation details.

NOTE: 352 mm (14 in) brakes shown, 325 mm (13 in) brakes similar.

  1. Remove the wheel and tire. For additional information, REFER to Section 204-04 .

  1. NOTICE: Do not allow the caliper to hang from the brake hose or damage to the hose can occur.

    NOTICE: Care must be taken when servicing rear brake components without disconnecting the parking brake cable from the brake caliper lever. Carefully position the caliper aside using a suitable support or damage to the parking brake cable end fittings may occur.

    Relocate and support the component. Discard the specified component. Follow local disposal regulations.

  1. NOTE: If necessary, thread a M10 bolt into the brake disc removal hole and tighten to press the disc off the hub.

    Discard the specified component. Follow local disposal regulations.

Installation

  1. Visual check. Wire brush. Clean the specified component with the specified material.
  1. To install, reverse the removal procedure.