SECTION 206-05: Parking Brake and Actuation
2014 Flex Workshop Manual
REMOVAL AND INSTALLATION
Procedure revision date: 05/02/2013
Parking Brake Cable — Rear
Removal and Installation
Both cables
Release the parking brake cable tension. For additional information, refer to
Parking Brake Cable Tension Release
in this section.
RH cable
Separate the RH cable from the LH at the conduit equalizer and remove the cable from the wireform bracket.
Remove the 3 parking brake cable bracket bolts.
To install, tighten to 15 Nm (133 lb-in).
Remove the RH wheel well bracket bolt.
To install, tighten to 23 Nm (17 lb-ft).
LH cable
Disconnect the conduit equalizer from the RH cable at the equalizer.
Remove the wireform bracket bolt and separate the LH cable and bracket from the RH cable.
To install, tighten bolt to 12 Nm (106 lb-in).
Remove the LH wheel well bracket bolt.
To install, tighten to 23 Nm (17 lb-ft).
Both cables
Release the parking brake cable from the brake caliper and remove the cable.
To install, reverse the removal procedure.
Inspect the parking brake system for correct operation.