Main Control Cover — 3.5L Ti-VCT

Removal

1. With the vehicle in NEUTRAL, position it on a hoist. Refer to Section 100-02 .

2. Remove the ACL assembly and outlet pipe. Refer to Section 303-12 .

3. Drain the transmission fluid.
   • Tighten to 9 Nm (80 lb-in).

4. Discard the specified component. Follow local disposal regulations.

5. NOTE: If the transmission fluid cooler tube seals or backing rings are stuck in the transmission case, remove the seals and backing rings.

9. NOTE: Note the location of the of the studbolts for assembly.

Installation

1. Check for damage. Visual check.

2. NOTE: Install the studbolts in the correct locations as noted during disassembly.

   Loosely install the bolts.

3. Tighten the main control cover bolts in the sequence shown.
   • Tighten to 12 Nm (106 lb-in).

4. • Tighten to 9 Nm (80 lb-in).

5. Visual check. Apply the specified lubricant to the specified component.
   Material: Motorcraft® MERCON® LV Automatic Transmission Fluid XT-10-QLVC.
   1. Seal
   2. Backing ring

6. Install a new transmission fluid cooler tube bolt.
   • Tighten the bolt to 9 Nm (80 lb-in).
   • Tighten the nut to 30 Nm (22 lb-ft).

9. Install the ACL assembly and outlet pipe. Refer to Section 303-12 .

10. Fill the transaxle with clean transmission fluid. Refer to Transmission Fluid Drain and Refill .