Transaxle Support Insulator — 3.5L GTDI

Special Tool(s)

	Bar, Engine Spreader 303-1454
	Eye, Engine Lift 303-1245
	Support Bar, Engine 303-F072

Removal

1. With the vehicle in NEUTRAL, position it on a hoist. Refer to Section 100-02 .

2. Remove the battery tray. Refer to Section 414-01 .

3. Remove the cowl panel grille. Refer to Section 501-02 .

6. Remove the crankcase vent tube. Refer to Section 310-00 .

12. NOTE: Index-mark the RH CAC tube position for reference during installation.

14. Special Tool(s): Eye, Engine Lift 303-1245.

15. Special Tool(s): Support Bar, Engine 303-F072, Bar, Engine Spreader 303-1454.

17. NOTICE: Do not loosen the center bolt or damage to the mount will occur.

    Remove the 2 upper transmission support insulator bolts.

Installation

1. Material: Threadlock and Sealer TA-25.
   • Tighten to 70 Nm (52 lb-ft).

2. Material: Threadlock and Sealer TA-25.
   • Tighten to 55 Nm (41 lb-ft).

3. Material: Threadlock and Sealer TA-25.
   • Tighten the bolt to 80 Nm (59 lb-ft).
   • Tighten the nuts to 63 Nm (46 lb-ft).

4. Connect the turbocharger wastegate regulating valve electrical connector.

5. Align the index marks.
   • Tighten to 5 Nm (44 lb-in).

7. • Tighten to 10 Nm (89 lb-in).

8. • Tighten to 15 Nm (133 lb-in).

9. • Tighten to 8 Nm (71 lb-in).

10. • Tighten to 6 Nm (53 lb-in).

12. • Tighten to 30 Nm (22 lb-ft).

14. Install the cowl panel grille. Refer to Section 501-02 .

15. Install the battery tray. Refer to Section 414-01 .