Transaxle Support Insulator — Anti-Roll, 3.5L GTDI

Removal

Front and rear roll restrictors

1. With the vehicle in NEUTRAL, position it on a hoist. Refer to Section 100-02 .

Front roll restrictor

3. If equipped.

Rear roll restrictor

Installation

Rear roll restrictor

1. NOTE: The bracket has keyed tabs to orient the roll restrictor.

   Wire brush. Apply the substance from the specified tube.
   Material: Threadlock and Sealer TA-25.
   • Tighten to 103 Nm (76 lb-ft).

Front roll restrictor

2. Wire brush. Apply the substance from the specified tube.
   Material: Threadlock and Sealer TA-25.
   • Tighten the 2 bracket-to-transmission bolts to 90 Nm (66 lb-ft).
   • Tighten the through bolt to 103 Nm (76 lb-ft).

3. If equipped.
   • Tighten to 70 Nm (52 lb-in).

Front and rear roll restrictors