All Wheel Drive (AWD) Systems

The AWD system consists of the following:

• PTU
• Rear driveshaft
• AWD relay module
• Rear axle with ATC solenoid

Torque from the engine is transferred through the transmission to the PTU . This torque is transferred from the driveshaft to the rear axle, which controls torque to the rear halfshafts. The AWD system is always active and requires no driver input.

The AWD system continuously monitors vehicle conditions and automatically adjusts the torque distribution between the front and rear wheels. During normal operation, most of the torque is delivered to the front wheels. If wheel slip between the front and rear wheels is detected, if the vehicle is under heavy acceleration or if the vehicle is in an aggressive handling event, the AWD system increases torque to the rear wheels to prevent or control wheel slip. When the AWD system is functioning properly, there should be no perceived speed difference between the front and rear axles when launching or driving the vehicle on any uniform surface. Traction should be similar to a part time 4WD system in 4H ( 4X4 HIGH), but have no binding in turns.

Serviceable components of the PTU are limited to the output shaft seal and flange, intermediate shaft seal and deflector, and the PTU transmission compression seal. No internal components are serviced. There should be no need to remove the PTU cover. If any of the internal geared components, bearings, case cover or shafts are worn or damaged, a new PTU must be installed.