SECTION 308-07B: Transfer Case — Power Transfer Unit (PTU)
| 2014 Flex Workshop Manual
|
SPECIFICATIONS
| Procedure revision date: 05/02/2013
|
| Item | Specification | Fill Capacity |
|---|---|---|
| Motorcraft® SAE 75W-140 Synthetic Rear Axle Lubricant
XY-75W140-QL (US); CXY-75W140-1L (Canada) | WSL-M2C192-A and GL-5 | 0.53L
(18 oz) |
Torque Specifications
| Description | Nm | lb-ft | lb-in |
|---|---|---|---|
| Drain plug (if equipped) | 12 | — | 106 |
| Driveshaft-to-output flange bolts a | — | — | — |
| EPAS electrical connector wiring retainer | 9 | — | 80 |
| EPAS heat shield bolt | 9 | — | 80 |
| Fill plug | 20 | — | 180 |
| Front roll restrictor bolts | 90 | 66 | — |
| Front roll restrictor through bolt | 103 | 76 | — |
| PTU bolts | 90 | 66 | — |
| PTU cooler heat sheild bolts (if equipped) | 12 | — | 106 |
| PTU coolant tubes bolt (if equipped) | 25 | 18 | — |
| PTU output flange nut | — | — | — |
| PTU support bracket-to-engine bolts | 48 | 35 | — |
| PTU support bracket-to- PTU bolts | 48 | 35 | — |
| PTU temperature sensor (if equipped) | 12 | — | 106 |
| Rear roll restrictor heat shield nuts | 9 | — | 80 |
| Rear roll restrictor through bolt | 103 | 76 | — |
| Rear roll restrictor-to-transmission bolts | 103 | 76 | — |
| Rear subframe bolts a | — | — | — |
| Steering shaft bolt a | — | — | — |
| Subframe bracket-to-body bolts | 55 | 41 | — |
| Turbocharger lower bracket bolts | 48 | 35 | — |
| Turbocharger-to-lower bracket bolt | 19 | — | 168 |