Steering Column Control Module (SCCM)

Removal and Installation

NOTE: Removal steps in this procedure may contain installation details.

1. If a new SCCM is being installed, connect the scan tool and upload the module configuration information from the SCCM . For additional information on configuration, refer to PMI in Section 418-01 .

2. Remove the steering column shrouds and steering wheel. Refer to Section 211-04 .

4. 1. To install, tighten to 3 Nm (27 lb-in).
   2. -

5. To install, reverse the removal procedure.
   • If a new SCCM was installed, it must be configured (using vehicle as-built data or module configuration information retrieved earlier in this procedure). For additional information on configuration, refer to PMI in Section 418-01 .