2014 Flex Workshop Manual

SECTION 412-01: Climate Control	2014 Flex Workshop Manual
REMOVAL AND INSTALLATION	Procedure revision date: 05/02/2013

Compressor to Condenser Discharge Line — 3.5L GTDI

Material
Item	Specification
Motorcraft® PAG Refrigerant Compressor Oil YN-12-D	WSH-M1C231-B

Item	Part Number	Description
1	W714077	Rear A/C compressor bolt
2	W520413	A/C compressor discharge fitting nut
3	W520413	Condenser inlet fitting nut
4	—	A/C pressure transducer electrical connector (part of 14290)
5	19972	Compressor-to-condenser discharge line
6	19B596	O-ring seal and gasket seal kit (1 required)

Removal and Installation

With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to Section 100-02 .

Recover the refrigerant. For additional information, refer to Section 412-00 .

Release the 4 underbody shield retainers and remove the underbody shield (if equipped).

Remove the lower radiator splash shield.

Remove the rear A/C compressor bolt.
- To install, tighten to 25 Nm (18 lb-ft).

Remove the A/C compressor discharge fitting nut and disconnect the fitting.
- To install, tighten to 15 Nm (133 lb-in).

Remove the condenser inlet fitting nut and disconnect the fitting.
- To install, tighten to 15 Nm (133 lb-in).

Disconnect the A/C pressure transducer electrical connector.

Remove the compressor-to-condenser discharge line.

To install, reverse the removal procedure.
- Install new gasket seals and O-ring seals.
- Add the correct amount of clean PAG oil to the refrigerant system. For additional information, refer to the Refrigerant Oil Adding procedure in Section 412-00 .

Evacuate, leak test and charge the refrigerant system. For additional information, refer to Section 412-00 .