2014 Flex Workshop Manual

SECTION 412-01: Climate Control	2014 Flex Workshop Manual
REMOVAL AND INSTALLATION	Procedure revision date: 05/02/2013

Condenser Core — 3.5L GTDI

Material
Item	Specification
MERCON® V Automatic Transmission Fluid XT-5-QM (or XT-5-QMC) (US); CXT-5-LM12 (Canada)	MERCON® V
Motorcraft® PAG Refrigerant Compressor Oil YN-12-D	WSH-M1C231-B

Removal and Installation

With the vehicle in NEUTRAL position it on a hoist. For additional information, refer to Section 100-02 .

Recover the refrigerant. For additional information, refer to Section 412-00 .

Remove the radiator. For additional information, refer to Section 303-03 .

Release the 2 transmission cooler line clamps and disconnect the lines from the condenser core.

Remove the 2 condenser fitting nuts and disconnect the fitting, and remove the condenser core.
- Discard the O-ring seals and gasket seals.
- To install, tighten to 15 Nm (133 lb-in).

To install, reverse the removal procedure.
- Install new gasket seals and O-ring seals.
- Add the correct amount of clean PAG oil to the refrigerant system. For additional information, refer to the Refrigerant Oil Adding procedure in Section 412-00 .

Evacuate, leak test and charge the refrigerant system. For additional information, refer to Section 412-00 .

Fill the transmission fluid to the correct level. For additional information, refer to Section 307-01 .