2014 Flex Workshop Manual

SECTION 413-13A: Parking Aid — Audible	2014 Flex Workshop Manual
REMOVAL AND INSTALLATION	Procedure revision date: 05/02/2013

Parking Aid Module (PAM)

Item	Part Number	Description
1	15T850	Parking Aid Module (PAM)
2	W707365	PAM pin-type screws (2 required)
3	15K864	Parking aid speaker
4	—	PAM electrical connector (part of 14A005)

Removal and Installation

NOTE: Module configuration is required when a new Parking Aid Module (PAM) is being installed.
Upload the PAM configuration information to the scan tool. For additional information, refer to Programmable Module Installation (PMI) in Section 418-01 .

Remove the RH C-pillar trim panel. For additional information, refer to Section 501-05 .

If replacing the parking aid speaker only, proceed as follows:
- Disconnect the electrical connector.
- Disengage the clips.
- Remove the parking aid speaker.

If replacing the PAM , proceed as follows:
- Disconnect the electrical connector.
- Remove the 2 pin-type screws.
- Remove the PAM .

To install, reverse the removal procedure.
- Download the configuration information to the PAM . For additional information, refer to PMI in Section 418-01 .