SECTION 417-01: Exterior Lighting
2014 Flex Workshop Manual
REMOVAL AND INSTALLATION
Procedure revision date: 05/02/2013

Fog Lamp Bulb


Item Part Number Description
1 — Fog lamp electrical connector (part of 14290)
2 13N021 Fog lamp bulb

Removal and Installation

 WARNING: The bulb contains gas under pressure. The bulb may shatter if the glass envelope is scratched or if the bulb is dropped. Handle the bulb only by its base. Avoid touching the glass envelope. Failure to follow these instructions may result in personal injury.

NOTE: The fog lamp bulb should not be removed from the fog lamp assembly until just before a new bulb is installed. Removing the bulb for an extended period of time may affect fog lamp bulb performance. Contaminants may enter the fog lamp assembly where they can settle on the lens and reflector. Never turn on the fog lamps with the bulb removed from the fog lamp assembly.

NOTE: Make sure the headlamp switch and ignition switch are in the OFF position.

  1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to Section 100-02 .

  1. NOTE: The bulb is removed by rotating it approximately one-eighth turn counter clockwise.

    Disconnect the fog lamp electrical connector and remove the fog lamp bulb.
  1. To install, reverse the removal procedure.