SECTION 417-01: Exterior Lighting
2014 Flex Workshop Manual
REMOVAL AND INSTALLATION
Procedure revision date: 05/02/2013

Stoplamp Switch


Item Part Number Description
1 — Stoplamp switch electrical connector (part of 14A005)
2 13480 Stoplamp switch

Removal

  1. Disconnect the stoplamp switch electrical connector.

  1. NOTE: The stoplamp switch is difficult to remove if the switch plunger is not depressed. A slight rearward force should be adequate to depress the plunger.

    With a light force, pull rearward on the brake pedal, rotate the stoplamp switch 45 degrees clockwise and remove the stoplamp switch.

Installation

NOTICE: It is very important not to press, pull or touch the brake pedal assembly during the installation of the stoplamp switch. Failure to follow these instructions may damage the stoplamp switch.

  1. Without movement to the brake pedal assembly, install the stoplamp switch and rotate 45 degrees counterclockwise.
  1. Connect the stoplamp switch electrical connector.

  1. NOTE: If the stoplamps do not operate correctly, repeat the removal and installation procedure with special attention not to move or touch the brake pedal during installation.

    Start the engine and apply the brake pedal several times to make sure the stoplamps operate correctly.