SECTION 419-01B: Anti-Theft — Passive Anti-Theft System (PATS), Without Intelligent Access (IA)
2014 Flex Workshop Manual
GENERAL PROCEDURES
Procedure revision date: 05/02/2013

Key Programming Using Two Programmed Keys

NOTE: This procedure works only if 2 or more programmed keys are available. If 2 programmed keys are not available, refer to Key Programming Using Diagnostic Equipment .

NOTE: This procedure works only if the customer spare key programming is enabled. If the customer spare key programming is disabled, REFER to Enable or Disable Spare Key Programming or Key Programming Using Diagnostic Equipment .

  1. Insert the first programmed PATS key into the ignition key cylinder and turn the ignition key cylinder to RUN (maintain the key in RUN for approximately 3 seconds).
  1. Turn the first key to OFF and remove the key from the ignition key cylinder.
  1. Within 10 seconds of turning the first key to OFF, insert a second programmed PATS key into the ignition key cylinder and turn the key to RUN (maintain the key in RUN for approximately 3 seconds).
  1. Turn the second key to OFF and remove the key from the ignition key cylinder.

  1. NOTE: The doors lock and then unlock to confirm that each IKT is programmed.

    Within 10 seconds of turning the second key to OFF, insert the new, unprogrammed PATS key into the ignition key cylinder and turn the ignition key cylinder to RUN (maintain the key in RUN for approximately 6 seconds).
  1. If it is desired to program additional keys, repeat Steps 1-5 for each additional key.