SECTION 419-10: Multifunction Electronic Modules
2014 Flex Workshop Manual
REMOVAL AND INSTALLATION
Procedure revision date: 05/02/2013

Remote Function Actuator (RFA) Module

Removal

  1. NOTE: This step is only necessary if the Remote Function Actuator (RFA) module is being replaced.

    NOTE: Prior to the replacement of the module, it is necessary to upload the module configuration information to the scan tool. This information must be downloaded into the new module after installation. For additional information, refer to Section 418-01 .

    Upload the module configuration information from the RFA module by following the scan tool on screen instructions.
  1. Remove the RH side instrument panel hush panel.
  1. Remove the 2 nuts and remove the RFA module.

Installation

  1. Install the RFA module.
  1. Install the RH side instrument panel hush panel.
  1. Download the RFA module configuration information from the scan tool to the new RFA module by following the scan tool on screen instructions.
  1. Carry out the parameter reset between the RFA module and the Body Control Module (BCM). For additional information, refer to Passive Anti-Theft System (PATS) Parameter Reset in Section 419-01B .
  1. Program the Intelligent Access (IA) keys (minimum of 2) into the new RFA module. For additional information, refer to Key Programming Using Diagnostic Equipment in Section 419-01B .
  1. Turn the ignition ON.
  1. Carry out the keyless entry keypad code reset. For additional information, refer to Keyless Entry Keypad Code Programming in Section 501-14B .
  1. Carry out the RFA module self-test to confirm all DTCs have been cleared.