Quarter Trim Panel

Removal and Installation

All vehicles

1. Position aside the liftgate weatherstrip.

2. Remove the liftgate scuff plate pin-type retainers.

3. NOTICE: To avoid damage to the liftgate scuff plate trim panel, remove any retaining clips from the body and attach them to the liftgate scuff plate trim panel before installing.

   Remove the liftgate scuff plate.
   • Pull upward to release the retaining clips.

4. Remove the C-pillar trim panel. For additional information, refer to C-Pillar Trim Panel in this section.

5. Remove the D-pillar trim panel. For additional information, refer to D-Pillar Trim Panel in this section.

6. NOTICE: To avoid damage to the scuff plate trim panel, remove any retaining clips from the body and attach them to the scuff plate trim panel before installing.

   NOTICE: To avoid damage to the scuff plate trim panel, remove the S-clips from the scuff plate trim panel and attach them to the door flange in the notches.

   Remove the rear door scuff plate trim panel.
   • Pull upward on the scuff plate trim panel to release the retaining clips.

7. Remove the quarter trim panel retaining screw.

8. Position the second row seats in the flat position and then tilt the second row seats forward.

9. Position the third row seats in the flat position.

10. Remove the cargo net retaining hooks.

Vehicles with a power liftgate

11. Remove the power liftgate motor. Refer to Section 501-03 .

All vehicles

12. Remove the quarter trim panel.
    • Pull the quarter trim panel toward the inside of the vehicle to release the retaining clips.
    • If equipped, disconnect the electrical connectors.

13. NOTICE: To avoid damage to the quarter trim panel, remove any retaining clips from the body and attach them to the quarter trim panel before installing.

    To install, reverse the removal procedure.
    • Initialize the liftgate. For additional information, refer to Section 501-03 .